MENU

100BASE SFP

Fast Ethernet (100BASE SFP) Defined

By our current industry standards, all Fast Ethernet (100BASE SFP) physical layers carry traffic at a set nominal rate of 100 Mbit/second. The previous Ethernet speed was for 10 Mbit/second. Out of the Fast Ethernet physical layers, 100BASE-TX is by far the most common.

First introduced in 1995 as the IEEE 802.3u standard, the Fast Ethernet (100BASE SFP) is was the fastest version of Ethernet for 3 years before the eventual introduction of Gigabit Ethernet. The industry acronym “GE/FE” is occasionally used for devices that support both of these established standards.

Sourcing 100BASE SFP module from OnisNetworking

As a reputable seller, OnisNetworking has established itself over the past 5 years in the 100BASE SFP module market. We proudly supply the 100BASE SFP module and our quality services to worldwide clients. All our 100BASE SFP module stock will be tested before shipping out to clients.

100BASE-T Defined

100BASE-T is defined as any of the several Fast Ethernet standards established for twisted pair cables, including: 100BASE-TX (100 Mbit/second over a 2-pair Cat5 or better cable), 100BASE-T4 (100 Mbit/second over 4-pair Cat3 or better cable, defunct), 100BASE-T2 (100 Mbit/second over 2-pair Cat3 or better cable, also defunct). The segment length for a 100BASE-T cable is limited to 100 metres (328 feet) (the same limit as 10BASE-T and gigabit Ethernet). All are, or were of standards under IEEE 802.3 (approved 1995). Close to all 100BASE-T installations are in 100BASE-TX.

100BASE-TX Defined

The 100BASE-TX is the predominant form of Fast Ethernet, and runs over 2 wire-pairs inside a category 5 or above cable set up. For each network segment, it can have a 100 meters (328 feet) maximum cable distance. One pair is used for each direction, which provides full-duplex operation with 100 Mbit/second of throughput for each given direction.

Like the 10BASE-T, the active pairs in a standard connection are terminated on pins 1, 2, 3 and 6. Since a typical category 5 cable will have 4 pairs, it can support a capacity of two 100BASE-TX links with a wiring adaptor. Cabling is usually conventionally wired to the TIA/EIA-568-B termination standard, T568A or T568B. This will place the active pairs on the orange and green pairs (ie: the canonical second and third pairs).

In terms of configuration, the 100BASE-TX networks are much like the 10BASE-T. When used in building a local area network, the devices on the network (such as the computers and printers) are typically connected to a hub or switch, which creates a star network. On the other hand, it is possible to connect 2 devices directly using a crossover cable. With present-day equipment standards, crossover cables are usually not needed, as most equipment supports auto-negotiation along with auto MDI-X to select and the match speed, duplex and pairing set up.

With 100BASE-TX hardware, the raw bits, presented in 4 bits wide clocked at 25 MHz at the MII, go through 4B5B the binary encoding process to generate a series of 0 and 1 symbols clocked at a 125 MHz symbol rate. The 4B5B encoding will provide DC equalization and spectrum shaping. As in the 100BASE-FX case, the bits are then transferred to the physical medium attachment layer through NRZI encoding. However, 100BASE-TX introduces an additional, medium dependent sublayer, which employs MLT-3 as a final encoding of the data stream before its transmission. This results in a maximum fundamental frequency of 31.25 MHz. This procedure is referenced from the ANSI X3.263 FDDI specifications, albeit with minor changes.